These can include steel bars or rods embedded within the countertop material or hidden steel brackets attached to the underside of the countertop. This type of support is typically a vertical panel that extends from the top of the cabinet to the ground and can be made from materials such as plywood, MDF, or the same material as the countertop.įor a sleek, modern look, you can opt for hidden support systems, which are not visible from the outside. Some cabinets and islands are designed with built-in support for waterfall countertops. These can be made of materials such as metal, wood, or acrylic, and should be strong enough to support the weight of the countertop. This is an example of a granite countertop design supported with corbels or brackets, in this case, the brackets are visible, if they are decorative they could be a very interesting element, if you don’t want them to be seen, you can hide the brackets with the covering and add a vertical support for the brackets to rest on and distribute the support forces to the floor.Īlso, Install support posts or legs at the end of the countertop, where the waterfall edge meets the ground. They can be placed under the countertop or attached to the wall. Posts can be made from wood, metal, or concrete. ![]() Corbels are decorative brackets that can be used to support the weight of the countertop.Īnother way to support a waterfall countertop is to use posts. ![]() One option is to use concealed supports that are attached to the underside of the countertop. The key to a successful installation is to make sure that the countertop is properly supported. The island support system can also be modified to support an overhang on all four sides of an island.However, waterfall countertops can be notoriously difficult to install. To support the ends we use our patented Island Extension Brackets that are mechanically fastened to the adjacent Island Bracket allowing us to support overhangs on up to three sides of the Kitchen Island. The flange is short enough so that it doesn't interfere with the drawers or doors. The brackets are then attached to the cabinet by way of a small flange with two screws. 5" slot is cut in the front of the cabinets for the brackets to rest in. The installation is a very simple process. Next we see the Island Brackets installed within the cabinets. ![]() Typically you will see an overhang on one side only as is it difficult to support overhangs on multiple sides without giant corbels. It’s a great bracket and perfect for most Countertop Islands.īelow are several images one of our customers sent us showing the Island Brackets in place.īelow we see the finished product with a 12 inch overhang on three sides. Once mounted the countertop support creates a cantilever, leveraging the weight of the countertop as well as the ½ inch steel. The countertop support then runs through the cabinet and rests in a ½ x 2 ½ inch notch in the back side of the cabinet.īefore the countertop is mounted we suggest that the installer apply a bead of “Liquid Nail” on the top of the countertop support. The flange is short, hidden from view and does not interfere with the operation of the drawers. The countertop support has a ½ inch x 4 inch flange on the back that mounts via two screws (the screws are provided with the countertop support) to the inside of the cabinet face frame. The Countertop Island Support is a solid ½ inch by 2 ½ inch steel bar that runs through the base cabinet (see the image above) and extends to the length of the overhang minus a couple of inches to keep the countertop support hidden from view. Countertop Island Supports are a great choice for supporting heavy countertops such as granite, quartz or butcher-block in an application where no knee wall exists and the countertop extends directly off the base cabinets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |